Functional Unit: Magazine Unit Type 1 - for up to 10 workpieces - fully assembled
The magazine unit type 1 separates workpieces for further processing. Cube halves are used workpieces for this.
The storage of the Magazine Unit Type 1 holds up to ten stacked workpieces. A pneumatic cylinder activated by a 5/2 way valve pushes the lowest workpiece out of the pile. Two micro switches check the load status of the magazine, and two reed switches monitor the position of the pneumatic cylinder.
The operating pressure equals 4 bar, and the operating voltage equals 24 VDC.
- Work planning, technical communication
- Testing, marking and identification
- Manual and mechanical machining, separating and reshaping
- Assembly work
- Design of electrical control systems
- Design of pneumatic control systems
- PLC programming
- Commissioning of mechatronic/electro-pneumatic systems
- Troubleshooting
- Automation of work processes
- Design and function of electro-pneumatic systems
Functional module as finished device
Delivery incl. digital media
library with
- Technical documentation
- Assembly instructions
- Multimedia content
Dimensions: 100 x 300 x 420 mm (L x W x
H)
Operating pressure: 4 bar
Operating
voltage: 24 VDC
Components:
- 2 x cylinder switch
- 1 x diffuse sensor
- 2 x microswitches
- 1 x 5/2 way valve
- 1 x double-acting pneumatic cylinder
Requirements for the PLC:
- 5 digital PLC inputs
- 2 digital PLC outputs