Digital, high-resolution 4-channel scope module for signal acquisition in automotive applications. Measurement results can be retrieved via connection to PC or tablet
Galvanic isolation between AVL DITEST SCOPE and PC
Electrical isolation protects the components of the AVL DITEST Scope from short circuits caused by voltage surges and ground loops. This prevents ground loops when measuring at grid-connected measuring points (e.g. socket) and on the PC. Defective components on the vehicle or measuring device are thus excluded.
Differential measuring channels
The differential measurement channels allow measurements at 40 MS/s each and full bandwidth. Each channel can be used independently of the others - so current, resistance and voltage measurements can be performed in parallel. Short circuits and faulty measurements during the measurement process are thus excluded.
Exemplary hardware
- Galvanic isolation of the channels and between measuring unit and PC
- Differential measuring channels
- Stimuli generator for active signal application
- Guided connection explanation of the sensors via Active Probe Supply with Color Guide
- Automatic zero adjustment and demagnetization (Degaussing)
- Guaranteed long-term measurement accuracy of 5 years without calibration
- Automotive Sensors
- Sturdy and ultra-light magnesium housing with rubber protectors
Sophisticated software
- Intuitive and self-explanatory operability
- Over 400 pre-configured measurements
- Automatic sensor recognition
- Guided measurement steps, connection explanations and detailed descriptions
- Automatic measuring range configuration
- Direct reference curve comparison
- Curve recorder function
Product advantages
- Galvanically isolated inputs
- 4 differential oscilloscope measuring channels with 40 MS/s each
- Active Probe Supply with Color Guide
- Over 400 predefined settings
- Voltage measurement up to 500 VDC/250 VAC
- Current measurement 1 mA to 1800 A AC/DC
- Resistance measurement from 0.1 Ω to 10 MΩ
- SPI for synchronous serial data bus
- Signal generator: 800 mA, -20 V to +20 V, up to 1 MS/s
- Resolution: Scope 14 bit, Digital Multimeter 16 bit
- Power supply via 14 V board power supply (cigarette lighter or car battery)
- Channel independent bandwidth and sampling rate
- AVL DiTEST Scope 1400 Module
- Power supply unit with power cord
- Cigarette lighter and vehicle battery Supply
- Cable USB
- 4 x cable URD
- 4 x test probes red
- 4 x test probes black
- 4 x crocodile clips red
- 4 x crocodile clips black
- Stimuli Cable set
- Current clamp I150 High End
- Current clamp I1800
- Temperature sensor -20° to 200°C
- Pressure sensor -1bar to 100bar
- Trigger pliers
- KV Clip
- CD manual
- Device case
- Packaging