The training stand has been developed for practical use in corresponding learning fields. In addition to wiring in accordance with the circuit diagram, diagnosis and programming using workshop testers via OBD is also possible. The necessary cable connections between the vehicle electrical system control unit and the installed components must be made by the trainee himself according to the wiring diagram. Laboratory cables with 4 mm safety sockets and different colour coding are used for better identification of the CAN connections between the control units. The inputs and outputs of the installed components are shown in digital print on the front panels. A special foil enables writing on the panels with water-soluble pens. This ensures high practical suitability. As circuit diagram, a continuous diagram drawn especially for this system or the original VW circuit diagram consisting of individual pages can be used.
- Working with circuit diagrams, circuit symbols, terminal designations, cables, cable connections
- Use of the possibilities of standard workshop diagnostic equipment
- Inclusion of problem-solving strategies or alternatives in the diagnosis
- Checking individual components and deciding on necessary repair measures
- Coding of control units, adaptation of software versions and testing of data communication lines in compliance with legal and manufacturer-specific regulations
- Create the cable connection according to the wiring diagram
- Troubleshooting the central electrical system via OBD diagnostic interface
- Naming electrical and electronic components, assemblies and systems
- Testing and repair of electrical and electronic circuits
- Selecting and using electrical measuring and testing equipment
- Measurement and evaluation of electrical quantities and signals
- Documentation of work results and evaluations by comparison with calculated values and manufacturer specifications
- Motor vehicle mechatronics technician with focus on passenger car technology
- Automotive mechatronics technician with focus on system and high-voltage technology
- Service technician
- Master Craftsman/Institute for Automotive Technician
Ready to use and mobile functional model, data sheets, circuit diagrams and operating instructions. Alternatively, the training stand can also be operated with a standard vehicle battery. The scope of delivery also includes all necessary connecting cables with 4 mm safety measuring sockets in different colours, the manual with practical examples, information sheets and worksheets as well as a continuously drawn and laminated circuit diagram.
- Immediately ready for use and mobile functional model
- All necessary connecting cables (laboratory cable with 4 mm safety sockets)
- Front side writable with foil pens
- OBD diagnostic interface
The following components are installed:
- Onboard power system control unit
- Steering column control apparatus with switch unit
- Diagnostic interface (gateway)
- Manual headlamp levelling
- Steering column control apparatus with switch unit
- Light switch
- Wiper motor
- H7 Main headlamp
- Front fog lamp with associated control unit
- Static cornering light
- Rear lights including rear fog light and reversing light (incl. reversing light switch)
- Raised stop light
- Brake light switch
- Hazard warning switch and interior light with door contact switch
- Control unit for static cornering light
- Power connection: 110/240 Volt mains connection 300
- Dimensions (L x W x H): 1,600 x 800 x 1,950 mm
- Weight: approx. 140 kg